|
Datasheet |
Unicast |
|
Number Of Streams : |
2 |
Format : |
H264/MJPEG |
Audio : |
Not Supported |
Resolution : |
4CIF, 2CIF, 528×320, CIF, QCIF |
Multicast |
|
|
Yes (See Limitations) |
Motion Detection |
|
Trigger Zones: |
1 Trigger Zone (See limitations) |
Trigger String: |
STARTMOTION_Z1 |
I/O |
|
Inputs : |
1 |
Outputs : |
1 |
Settings |
|
Serial Port : |
Not Supported |
PTZ Control : |
Not Supported |
Cathexis Software : |
CatVision 2014 and later |
Camera Firmware : |
V2.0 120423 |
Limitations : |
- A camera Reboot is required in order for certain camera functions to take effect.
- A typical camera reboot takes between 50-60 seconds.
- Multicast will work but the camera only streams to port 8602 and not the configured port.
- Therefore it may be possible to to use the multicast functionality by configuring the multicast UDP port to 8602.
- When setting VMD, it is also important to set the “Deployment time” along with ticking “Trigger alarm output” under “Linkage”.
- The VMD on this encoder is very poor.
|