http://www.axis.com/

This camera driver supports older MPEG4 cameras as well as newer H264 Cameras.

P1357
CathexisVision Camera Integration
Driver:


  Datasheet
Unicast  
Number Of Streams : 4
Format : H264/MJPEG
Audio : Bi-directional  
Resolution : 5.0MP (2592×1944), 3.1MP (2048×1536), 2.0MP (1920×1080), 1.9MP (1600×1200), 1.3MP (1280×1024), 1.2MP (1280×960), 1.0MP (1280×800), 0.9MP (1280×720), XGA (1024×768), 480kP (800×600), 360kP (800×450), VGA (640×480), 230kP (640×360), 172kP (480×360), 129kP (480×270), QVGA (320×240), 57kP (320×180), 43kP (240×180), QCIF (176×144), 19kP (160×120) and 14kP (160×90)
Multicast  
Format :   H264
Resolution :  5.0MP
Audio : Bi-directional 
Motion Detection  
Trigger Zones :  1
Trigger String: STARTMOTION, TAMPER and AUDIO.
I/O  
  Yes
PTZ   
PTZ Control: Yes
Setup:
  1. Download ptz driver for your specific camera from axis website support section
  2. Default camera, and configure root password
  3. Login to the cameras web interface. When presented with ptz mode setting, select “Uploadable PTZ driver”.
  4. Complete setup of the camera.
  5. Go to the PTZ tab and click on “Choose File” and select the driver. Note: If Ptz tab is not presented, return to step 1.2
  6. Click on “Upload”.
  7. Make sure Select driver to use : Pelco[4.09] and Activate PTZ.
  8. Device Type is “Generic”.
  9. Go down to “System Options” and click on ” Ports & Devices”.
  10. Click on COM port and setup the serial port baud rate etc.
  11. Ensure that the port mode is set to “RS422-2/4 wire”.
  12. Go on Catsite and edit the cameras settings. Enable PTZ and use the on board configuration.
Settings  
Cathexis Software : CatVision 2014 Service Pack 1 and later
Camera Firmware : V 5.40.19
Limitations :  
Cathexis Integrations