Datasheet |
|
|
Unicast |
|
CathexisVision Driver: |
Samsung V2 |
Number Of Cameras: |
1 |
Number Of Streams: |
Up to 10 |
Format: |
H264/MJPEG (H265 see limitations) |
Transport: |
Default, RTP/TCP and RTP/UDP |
Audio: |
Listen only |
Resolution: |
3.9MP (2592×1520), 3.6MP (2560×1440), 2.9MP (2304×1296), 2.0MP (1920×1080), 1.3MP (1280×1024), 1.2MP (1280×960), 0.9MP (1280×720), XGA (1024×768), 480kP (800×600), D1 (720×576), 358kP (800×448), D1 (720×480), VGA (640×480), 230kP (640×360), QVGA (320×240) |
|
|
Multicast |
|
Format: |
H264 |
Audio: |
Listen only |
|
|
Camera Events |
Motion Detection: |
Yes |
Zones: |
1 |
Trigger Message: |
STARTMOTION |
|
|
Tamper Detection: |
Yes |
Trigger Message: |
STARTTAMPER |
|
|
Defocus Detection: |
Yes |
Trigger Message: |
STARTDEFOCUS |
|
|
I/O |
|
Inputs: |
Yes. 1 Input |
Outputs: |
Yes. 1 Output |
|
|
Settings |
|
Edge Review: |
Not Supported. |
Serial Port: |
N/A |
PTZ Control: |
Zoom in/out and Focus near/far |
Cathexis Software: |
CathexisVision 2017 SP2 and later |
Camera Firmware: |
1.00_160804 |
|
|
Notes: |
- The format of the first three profiles cannot be changed as it is set on the camera.
- When setting up a stream using Live555 (RTP/TCP, or RTP/UDP) it may take up to 15 seconds for the live stream and audio to syncronize. The recordings during this time is correct.
|
|
|
Limitations: |
- H265 has not been tested, but is supported from CathexisVision 2017.3.
- Edge review is not supported
- The camera presents CathexisVision with ten possible video feeds to configure, but may not be able to use all of them.
- The camera will report to CathexisVision that a framerate of 5FPS can be used for all resolutions in the first video feed, but the web interface shows that for higher resolutions only framerates less than 5FPS can be set. When editing the camera, the settings won’t be saved if an unsupported framerate is selected.
- Camera doesn’t support auto focus.
- The camera doesn’t always stream the first video feed according the framerate set.
|
|
|