Santec SNC-3342
CathexisVision Camera Integration
Driver:


  Datasheet
Unicast  
Number Of Streams : 2
Format : MPEG4, JPEG
Audio : Listen Only
Resolution : 1.9MP (1600×1200), 0.9MP (1280×720), 480kP (800×600), D1 (720×576), D1 (720×480), VGA (640×480), CIF (352×288), CIF(352×240), QVGA (320×240)
Multicast  
  Not Supported
Motion Detection  
 Trigger STARTMOTION_Z1
Setup See limitations
I/O  
  Not available
Settings  
Cathexis Software : CatVision 2014 service pack 4 and later
Camera Firmware : 1.0.0.12
Limitations :  

VMD Setup:

    • Setup motion detection zones Setup -> Event -> Motion Detection
    • Then go to Setup -> Event -> Event Configuration
    • Under Event Type List click on add.
    • In Event Type Setup:
    • Select Respond to Trigger : Always
    • Select Trigger by: Motion Detection
    • In Window: Select the zone you want to trigger from
    • In the When triggered… section select Send Meassage notification (TCP)
    • Server IP, IP address of the NVR
    • Server Port 32305
    • Message STARTMOTION_Z1
    • Retry 0
Cathexis Integrations