|
|
Unicast |
|
Number Of Streams : |
Up to 4 |
Format : |
H264/MJPEG |
Audio : |
Bi-directional (See setup notes) |
Resolution : |
5MP |
Multicast |
|
|
Not supported |
Motion Detection |
|
Trigger Zones : |
4 |
Trigger String : |
See setup notes |
I/O |
|
Inputs : |
1 |
Outputs : |
1 relay output |
Settings |
|
Serial Port : |
RS485 PTZ Control |
PTZ Control : |
Yes |
Cathexis Software : |
CatVision 2014 and later |
Camera Firmware : |
z120121116NSA |
Setup Notes : |
|
|
- Audio format needs to be set up on the web interface as G711u or G711a.
- To have access to the audio output, the duplex mode needs to be set to full/half/post.
- Motion / Tamper detection notifications need to be set up on the camera as follows:
- System->HTTP: Set up Http server to ‘:32305’
- System->Motion Detection: Set up motion detection window and set trigger action to ‘Send Http notification’, select Http server and trigger string in custom parameters
- System->Tampering: Enable tampering alarm and set trigger action to Send Http notification’, select Http server and trigger string in custom parameters
|
Limitations : |
|
|
- Video streams need to be set up on camera; can not be modified from Catsite.
- CatVision 2014 Service Pack 1 or later, addresses a unique Dynacolor I frame configuration, that results in video playback (on review) appearing to “jerk”. Service Pack 1 corrects for this.
|